Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - EZRider

Pages: [1]
For Sale/Wanted / Engine mount for sale
« on: August 20, 2017, 09:38:39 PM »
Lycoming type 2 Cozy III Engine mount for sale. $450.00

For Sale/Wanted / Longez nose wheel
« on: July 12, 2014, 07:03:23 AM »
Found during the condition inspection mine is damaged.

Hangar Flying / Posting
« on: July 03, 2014, 04:08:07 PM »
I'm trying to post a small picture and it says the upload folder is full!  What's up with that?

Hangar Flying / Roncz canard elevator balance
« on: May 15, 2013, 06:31:52 PM »
Weight is good for the elevators at 3.3 and 3.7.  Balance is leading edge down.  Since the weight is good should I take some off the balance weights and try to get closer to a perfect balance or is nose down good?

For Sale/Wanted / Smart Coupler II
« on: April 26, 2013, 01:57:14 PM »
Need a Smart Coupler, mine seems to have failed :( Thought someone might have one laying around after removing their Navaid Autopilot.

Hangar Flying / EZ ride
« on: December 08, 2012, 12:39:22 PM »
I live in Tucson and am looking for a back seat ride to get familiar with the Longez or Varieze.  I am purchasing a Varieze and would like to buy fuel for a backseat ck.

Hangar Flying / Longez Gear Leg Fairings for Sale
« on: December 19, 2011, 07:18:40 PM »
I have a set of unused Light Speed Longez gear leg fairings for sale.  $500.00

Hangar Flying / Wright Nose Lift
« on: December 27, 2008, 10:01:10 AM »
What size circuit breaker should be installed.  It is not indicated on the drawings that came with the nose lift kit.

Hangar Flying / NACA Scoop
« on: July 30, 2007, 10:33:13 PM »
Is the NACA Scoop notched into the bottom of the fuselage and firewall or does it just lay on top?

Hangar Flying / Oil Heat
« on: February 23, 2007, 05:42:24 PM »
I am planning on oil heat for the Longez.  I plan to put the oil cooler in the hell hole.  Does anyone have an idea for a blower motor, besides Waiter's 1982 rabbit blower motor.  Waiter's 10 amp circuit braker seems a bit much for this installation.  I'm looking for a motor that will be do the job,but with minimum power requirements.

Hangar Flying / Waiter
« on: February 25, 2006, 06:38:50 PM »
Website has not been updated for some time, have you stopped working on the project? :D

Hangar Flying / X-Plane V8
« on: December 03, 2005, 09:02:19 AM »
Is there a Longez for X-Pane V8?

Hangar Flying / Gas Caps
« on: October 03, 2005, 07:02:51 PM »
I am getting ready to install the Gas Caps in my Longez project.  Has someone had a recent experience and have a recommendation for a good solution?

Pages: [1]