Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - atfloyd

Pages: 1 [2]
16
For Sale/Wanted / wanted nose gear
« on: May 17, 2007, 12:08:22 PM »
Looking for a nose gear assembly for a long ez

17
Hangar Flying / Forward hatch latch/release
« on: May 08, 2007, 06:34:27 PM »
Hey folks...I have built an extended nose with "C" type hinges for the forward hatch.  I need to see if anyone has a latch design or ideas to that effect for the forward hatch.  I need a design that will release from the side via a cable inside the fues.  I have seen them out there but can't seem to track one down.  Any help would be appreciated.  Thanks


Allen
milehighlongez.com

18
Hangar Flying / Battery
« on: April 23, 2007, 02:38:39 PM »
Any recommendations for a battery to use in an extended nose EZ.

19
Hangar Flying / Forward hatch latch
« on: February 18, 2007, 03:46:40 PM »
For those of you who have installed thier forward hatches with the C/J hing mod.  I am looking for a good latch that you can use from the cockpit via a cable.  Any input, plans or ideas?  Thanks

Allen

20
Hangar Flying / Electric roll trim
« on: March 17, 2006, 11:09:29 AM »
Anyone have any luck with a Ray Allen servo in thier roll tim setup?  I am looking for alternatives to the plans trim system.  Thanks

Allen

21
Hangar Flying / ENGINE OVERHAUL
« on: March 11, 2006, 07:10:27 AM »
I need a recommendation for a good engine overhaul shop.  It is time to mount my engine, so I need to get it ready. Thanks

22
Hangar Flying / CS 132 bellhorns
« on: March 05, 2006, 09:59:44 AM »
With Brock no longer selling parts and Spruce somewhere in limbo, does anyone have a lead on a set of CS132 bellhorns?  Thanks

23
Hangar Flying / rotary power
« on: February 24, 2006, 10:51:13 PM »
Hi folks, I am doing some research on a rotary motor for my Long Ez.  anyone have any experience in this mod. Any input would be great..
Thanks...

24
Hangar Flying / Century Springs for hidden rudder bellcrank mod
« on: February 10, 2006, 09:39:58 PM »
Any one have a set of century springs Part#1887 for the hidden rudder bellcrank mod.  I tried to order a set from Century but they have a $30 minimum order.  Kind of steep for 2 spring.  If any one else needs them I can place an order for 14 springs and that should cover the spread.

Allen

25
Hangar Flying / wright nose lift electrical schematic
« on: February 09, 2006, 12:37:27 PM »
Hi, Thanks for the response.  I did get intouch with Steve and he got me all set up.  
Thanks again.

 Allen

26
Hangar Flying / wright nose lift electrical schematic
« on: January 18, 2006, 09:30:29 AM »
I have installed my nose lift but do not have the electrical schematic.  I tried to get in touch with Steve but no luck.  Any one have a set that I might gander at?  I appreciate any assistance.  

Allen 8)

27
Hangar Flying / Wright nose lift plans
« on: January 15, 2006, 08:48:36 PM »
I have bought a Wright nose lift and did not get any plans.  Does anyone have a set that I might get a copy of.  I need to find the measurements for the hole in bulkhead for the actuator to stick through..

Thanks

Allen

28
Hangar Flying / Space saver electrical panel
« on: December 26, 2005, 07:10:50 PM »
I am looking for a space saver electrical panel for my LEZ project.  I have seen them on some EZ's but don't know where to find one.  Any help would be great. Thanks

Allen

Pages: 1 [2]