Author Topic: Battery  (Read 8734 times)

0 Members and 1 Guest are viewing this topic.

Offline atfloyd

  • Newbie
  • *
  • Posts: 28
    • View Profile
Battery
« on: April 23, 2007, 02:38:39 PM »
Any recommendations for a battery to use in an extended nose EZ.

Offline Waiter

  • Newbie
  • *
  • Posts: 306
    • View Profile
    • http://www.iflyez.com
Battery
« Reply #1 on: April 23, 2007, 04:08:26 PM »
The only battery I would EVER use in an airplane.

Odessey PC925MJT

Odessey makes several different sizes.  The thing I love about this battery, you can mount it in ANY position, even upside down if you wanted to.  No spillage, no acid.  and Plenty of OMPH.

You can deep cycle it, no problem, put a charge back on it and your good to go.  Of course I know you would never leave the master ON :-)

Waiter
LongEZ-RG   >>    N961EZ
O-320 160hp  >>    MT Constant Speed Prop
F-16 Performance, On a Piper Cub Budget
www.iflyez.com

Offline GlennBob

  • Newbie
  • *
  • Posts: 261
  • Eph 2 : 8 & 9
    • View Profile
Battery
« Reply #2 on: April 24, 2007, 12:38:01 AM »
I wanted to instal  IDIOT  lights in my easy, . . in case my alt.  died or such and my voltage dropped.  I wanted to know right away since I don't have mags, but two lightspeed plazma units.  Turns out, . .I already had a B & C voltage regulator and all I had to do was run a wire from ( I think ) the 5th terminal to my light and then to the + pos. of the battery.  When the alt is singing, . .the light is off, . .when it's not, . .the light flashes !! !  This is a great reminder if the engine is off and the master is left on.  The bulb flashes fast at first and slows as the voltage drops.  This should help remind the situation.

Glennbob
N600EZ  O-320-E2A,  Hertzler prop, Trio AP, Narco HSI, Custom headers, Oil heat.

Offline GlennBob

  • Newbie
  • *
  • Posts: 261
  • Eph 2 : 8 & 9
    • View Profile
Battery
« Reply #3 on: April 24, 2007, 12:45:34 AM »
There was a link that I had about an experimental battery.    Do a google on " Kilacycle.com " and watch the video of the electric drag motorcycle.  They had some info on a 12volt unit being tested in a Chevy Van, but the link I had expired.  Wasn't cheap but was supposed to be super performer.

Glennbob
N600EZ  O-320-E2A,  Hertzler prop, Trio AP, Narco HSI, Custom headers, Oil heat.

Offline Juan Rivera

  • Newbie
  • *
  • Posts: 31
    • View Profile
Battery
« Reply #4 on: April 25, 2007, 08:29:53 PM »
I have used two B&C batteries.  Never had any problems.  I like to support the small companies that make us quality products.

Offline Hangar14

  • Newbie
  • *
  • Posts: 17
    • View Profile
Battery
« Reply #5 on: April 25, 2007, 09:14:54 PM »
Well, I said I was going to do it and we finally got the prototype
built.

We just built a 600 cranking amp, 11.5 A-hr, battery that weighs just
3.7 pounds. I've been testing it in my GMC van for the past week here
in the Denver Winter. It snaps the van right over every morning
without a problem. The van cranks faster than it did with the
standard lead-acid battery.

It is smaller than the Odyssey 680 so it fit in the same battery box
with a couple of foam blocks for spacers.
The battery has four status LEDs that tell you the cell balancing
electronics are working OK. We are using A123 Systems M1 cells with
our own custom battery management electronics. The A123 Systems cells
are proven to be the safest Li-Ion cells on the market. No problems
with fires (like laptop cells) because the chemistry they use is
completely different.

The battery can be damaged by running it completely flat (like
leaving the master on) and holding the battery below 8 volts for a
long time. It can also be damaged by charging it over 15.0 volts. It
will likely still function after such abuse, but it won't be nearly
as good as it was originally. If you don't abuse it, it should last
you for many years.

I think we will be in production in about a month, maybe two.

Specs:

3.7 lbs
600 cranking amps
11.5 amp-hr
Approximate maximum dimensions: 3" wide, 5" long, 7" tall (including
terminals)
Charging voltage = 13.8 to 15.0 volts (anywhere in this range is OK)
Nominal voltage = 13.2 volts (Just a touch higher than your typical
lead-acid, so it spins the starter a touch faster.)
Cell cycle life rated at 2000 cycles (80% DOD, 90% capacity
remaining) 10,000 cycles (80% DOD with 50% capacity remaining) @25 C
Cell specs:

<http://www.a123systems.com/html/products/ANR26650M1specs.pdf"http://www.a12

3systems.com/html/products/ANR26650M1specs.pdf>http://www.a123systems.com/ht
ml/products/ANR26650M1specs.pdf

Maintenance free
No heavy metals (iron-phosphate type cells)

At this time, we estimate the retail price will be $595. (Yeah, I
know this is not cheap, but this is the state-of-the-art battery
technology so the parts to make it are not cheap.)

Here is a picture of the prototype. We have it in a clear Lexan case
so we can keep an eye on it. The production battery will have a
smaller opaque case with a clear top lid (terminal end.)
http://www.killacycle.com/photos/aircraft-battery/Prototype1InVan.JPG


We have been racing these cells in the KillaCycle for about a year,
so we know _all_ about them.

<http://www.KillaCycle.com"http://www.KillaCycle.com>http://www.KillaCycle.c
om (Be sure to
watch the movie clip.)



We figured that most folks would want a battery that had the cranking
amps to easily spin the starter and would not care much about the a-hrs.

The cost is directly proportional to the amp-hrs. If we were to go to
16 amp-hrs (it's easy to do) the cost would go up to about $850. The
cranking amps would also go up in proportion too. Figure about $1 per
cranking amp, and about $50 per amp-hr and you won't be far off. The
steps are 2.3 a-hr and 120 cranking amp increments. You pick.

This battery REALLY spins the starter in my GMC van. When I turn on
the key in the morning, the battery voltage is typically 13.4 volts
(instead of 12.8 volts.)

Anyone in the Denver area that flies daily interested in flight
testing one of these? You would get to keep the battery and write
anything you want about it (good or bad) as long as it was truthful.
You would have to inspect it before and after each flight including
noting the voltage and the BMS indicator light status. You must sign
the usual liability waiver we are all now accustomed to of course. :-)

You need to isolate it from over and under voltage as much as you
would your present sealed lead-acid battery. I would suggest a buzzer
connected to a door switch to warn you that you have left the master
on. You should also have a warning light on the panel for over and
under voltage. You should have these already.

Keep in mind that this battery will withstand over and under
voltage. It just "wounds" it much like such mistreatment "wounds"
your present sealed lead-acid battery. This battery will take the
abuse without creating an additional hazard. Other, less safe, types
of Li-Ion batteries will do very bad things (like burst into flames)
if you subject them to abuse.

You wouldn't want to use anything other than a warning
system for over and under voltage. This would cause a hazard greater
than letting the battery "take the abuse". There is no danger in
abusing the battery other than reducing its capacity for later use.

To give you an idea of how tough these batteries are, we
routinely heat these up to 100 C (212 F) in the bike. We routinely
draw 50% more than their rated current. We routinely go below the
minimum voltage (briefly.) We have accidentally over charged some of
these cells. Yet, despite this abuse, we have never had to replace a
single one of the 880 cells in the bike.

These are not the delicate Li-Ion cells that they put in
your laptop or cellphone.

Bill Dube'
bike@KillaCycle.com
Chuck

Offline GlennBob

  • Newbie
  • *
  • Posts: 261
  • Eph 2 : 8 & 9
    • View Profile
Battery
« Reply #6 on: April 25, 2007, 10:38:13 PM »
Just like the other link, . . .this one is expired too.

Glennbob

P. S.  Hope the battery performs better than this ! !
N600EZ  O-320-E2A,  Hertzler prop, Trio AP, Narco HSI, Custom headers, Oil heat.

Offline Hangar14

  • Newbie
  • *
  • Posts: 17
    • View Profile
Battery
« Reply #7 on: April 26, 2007, 12:15:05 PM »
Chuck

Offline mwilli7119

  • Newbie
  • *
  • Posts: 55
    • View Profile
battery
« Reply #8 on: April 26, 2007, 12:28:56 PM »
I couldn't find anything on the website about airplane batteries. Some very pretty position lights, but no batteries.

Mike

Offline miketdrew

  • Newbie
  • *
  • Posts: 22
    • View Profile
    • http://michaeltdrew.com
Battery
« Reply #9 on: April 26, 2007, 03:08:06 PM »
Try looking under the Killacycle Photo tab on their website.   12v racing battery.
Had VariEze N840EZ LyCon 235 Flying

Offline flyingwaldo

  • Moderator
  • Newbie
  • *****
  • Posts: 274
    • View Profile
Odyssey Batteries
« Reply #10 on: April 26, 2007, 03:19:14 PM »
I've been very impressed with the Odyssey battery that was recommended when I was looking for a replacement.  I got the smaller one, 680 vs. the 925 for ease of mounting right now.  Will look into the 925 for the extra weight when switching engines this fall.  It's remarkable such a little battery can crank an O-320 so very easily.  Can be mounted in any position as it is sealed.

Offline mwilli7119

  • Newbie
  • *
  • Posts: 55
    • View Profile
killacycle
« Reply #11 on: April 27, 2007, 09:41:23 AM »
Ok, is this for real? Is anybody flying with it?
It looks great, but I don't want to killame.

Mike