Javascript must be enabled to use this website

Long-EZ or Varieze nose gear repair

Sid Tolchin

Prior to a recent flight, when on the ground and during preflight check, the nose gear could be retracted and extended normally using the standard manual gear installation, in place since 1979. Because of CG balance, and as is somewhat usual in the VariEze, the force necessary to lift the nose on the ground with gear extended is minimal.

For safety, either a weight is placed on the pilot’s seat or a weight (battery) is hung from the nose gear so that the plane will not fall backward onto its prop and winglets when not attended, especially when sightseers are around feeling and touching. When at a remote location, the same safety has been achieved by lowering the gear slightly so that more force is required to upend the fuselage.Until now, I have not been in the habit of fully retracting the gear and placing the nose on the steel skid for very short parking periods.

Recently, at a washstand, this method was used. Leaning over the canopy and inadvertently applying body weight while washing the plane in this position, I noted the nose dropped several degrees. I attributed this to a spontaneous gear retract handle rotation, the gear not having been in the over center position. Holding the nose level then, the gear could be retracted and extended with no problem.

The gear retract mechanism was inspected visually through the battery panel opening, retracted and extended multiple times and the plane was flown several times with no difficulty thereafter.

During a recent flight, the gear was retracted manually after takeoff on crosswind leg and noted to remain in mid position. Attempts thereafter to raise the gear fully, or to lower the gear fully, failed. The gear remained in mid position dangling in the slipstream while attempts to lower it were unsuccessful. These attempts included slowing to full stall at 60-70 mph, high G turns while cranking furiously, rapid pitch changes and vocal epithets. When nothing worked, the tower was called and notified of the problem and equipment was placed on standby.

The approach used was slow and controlled with touchdown on the numbers at 75-80 mph. The canard was held up with full back stick and trim and with no braking. Because of ground effect, lowering of the nose did not occur until less than 50 mph while in this stick position. Then, possibly because the gear was still in mid position before it collapsed, the nose skid did not touch the asphalt until about 35 mph. A short and pleasantly controllable skid, with minimal braking, occurred until stop some twenty or thirty feet later.

After exiting the plane, I lifted the nose and was surprised to note that I could easily rotate the gear handle to a solid over center gear down position, got back in and taxied to the hangar. Once again, the nose gear could be raised and lowered without any problem unless pressure, similar to the wind effect, was applied to the faceplate in front of the wheel at which time slipping was noted.

After removing the canard, the worm gear assembly was inspected and no obvious problems were seen. However, when looking at the cast iron gear cogs near the spiral gear with a mirror, the wear was very apparent.

Copyright 1999-2017 ez.org All Rights Reserved